860020 8 pin direct fit decoder
Interface: 8 pin plus purple FO2 Wire. 2 Stay alive wires, blue +ve and black -ve for Lais stay alive kits and a NEM652 8 pin. For detailed information, please refer to the manuals.
Rating: 1A continuous, 2A peak
Scale: HO & N scale
Functions: 4 at 100mA each
Standard: NMRA DCC
Not Support: ABC, Railcom, Motorola
Total support of all NMRA/NEM specifications
Direct easy connection to exclusive Stay-Alive device.
Super smooth high frequency silent drive motor control.
Switchable DC running
4 digit addressing and 14, 28 or 128 speed steps.
4 active functions each safe to 100mA
Support for all common programming & consist modes.
Back EMF with step-variable or Fn button control.
Fully adjustable motor control and function actions.
Easily locked once adjustment or set-up is complete.
All special lighting effects available
All functions able to be re-allocated (remapped) as required.
Heat-shrink insulated for short-free installation.
Economical enough to use as lighting decoders.
2Amp peak power, 1A continuous, Functions 100mA
Reset by CV8=4 or CV30=4
LaisDcc motor decoders can be also used as function decoders. You just need to connect a 560ohm/0.25W resistor between the grey wire and the orange wire to make it to a dummy load/motor. Then you can use it as a function only decoder and you can change the mapping and light effects after the installation. You do not need to take it out to connect to a motor to do the CV settings.