Lais DCC 860019 21 Pin 6 Function Decoder

£13.50
Lais DCC 21 pin MTC decoder Order Number : 860019
Availability: In stock
Only 139 left
SKU
860019

860019 21 pin MTC decoder Pan Gu series decoder not for use with high power stay alives

6 Function decoders with 21MTC/NEM 660/MTX interface standard.

Note: If CV7=4, you have 6 functions, It has extra MTC Aux 3 and Aux 4 with logic output only. This is compatible with ESU 51900 DCC DECODER TESTER, you can use it with this decoder tester.

For detailed information, please refer to the manuals. http://laisdcc.com/LaisDcc_Decoders_Manual_V2.pdf

Rating: 1A continuous, 2A peak Scale: HO & O scale

Functions: 6at 100mA each

Standard: NMRA DCC

Does NOT Support: ABC, Railcom, Motorola. High power stay alives.

LaisDcc Total support of all NMRA/NEM specifications

Direct easy connection to exclusive Stay-Alive device.

Super smooth high frequency silent drive motor control.

Switchable DC running 4 digit addressing and 14, 28

Support for all common programming & consist modes.

Back EMF with step-variable or Fn button control.

Fully adjustable motor control and function actions.

Easily locked once adjustment or set-up is complete.

All special lighting effects available

All functions able to be re-allocated (remapped) as required.

Heat-shrink insulated for short-free installation.

Reset by CV8=4 or CV30=4

Set Up Guide the for Lais DCC 21 pin decoder in Dapol 68.

Set loco internal switch 3 to position 1

Then configure your decoder with the following CV settings.

These will give you whites directional on F0

Reds No 1 end directional on F1 and 

Reds No 2 end directional on F2

CV = Value

34=4

35=2

36=8

50=16

51=16

52=0

For non directional control of reds so you can leave them on when you want, for example parking lights set 

CV = Value

50=32

52=32

LaisDcc motor decoders can be also used as lighting function decoders. You just need to connect a 560ohm/0.25W resistor between the motor outputs to make it to a dummy load/motor. Then you can use it as a function only decoder and you can change the mapping and light effects after the installation. You do not need to take it out to connect to a motor to do the CV settings.

More Information
Featured Product No

Best Selling Products

OUR STORY

ESTABLISHED IN 2005

The idea of Digitrains was conceived over the dinner table and grew very slowly as doubts calmed missionary zeal. We finally took the plunge in January 2005 and are fortunate to be dealers for some of the best and most user friendly DCC equipment available.

READ THE FULL STORY

or

Watch our video

Please be aware that we no longer accept cheques as payment