860019 21 pin MTC decoder Pan Gu series decoder not for use with high power stay alives
6 Function decoders with 21MTC/NEM 660/MTX interface standard.
Note: If CV7=4, you have 6 functions, It has extra MTC Aux 3 and Aux 4 with logic output only. This is compatible with ESU 51900 DCC DECODER TESTER, you can use it with this decoder tester.
For detailed information, please refer to the manuals. http://laisdcc.com/LaisDcc_Decoders_Manual_V2.pdf
Rating: 1A continuous, 2A peak Scale: HO & O scale
Functions: 6at 100mA each
Standard: NMRA DCC
Does NOT Support: ABC, Railcom, Motorola. High power stay alives.
LaisDcc Total support of all NMRA/NEM specifications
Direct easy connection to exclusive Stay-Alive device.
Super smooth high frequency silent drive motor control.
Switchable DC running 4 digit addressing and 14, 28
Support for all common programming & consist modes.
Back EMF with step-variable or Fn button control.
Fully adjustable motor control and function actions.
Easily locked once adjustment or set-up is complete.
All special lighting effects available
All functions able to be re-allocated (remapped) as required.
Heat-shrink insulated for short-free installation.
Reset by CV8=4 or CV30=4
Set Up Guide the for Lais DCC 21 pin decoder in Dapol 68.
Set loco internal switch 3 to position 1
Then configure your decoder with the following CV settings.
These will give you whites directional on F0
Reds No 1 end directional on F1 and
Reds No 2 end directional on F2
CV = Value
34=4
35=2
36=8
50=16
51=16
52=0
For non directional control of reds so you can leave them on when you want, for example parking lights set
CV = Value
50=32
52=32
LaisDcc motor decoders can be also used as lighting function decoders. You just need to connect a 560ohm/0.25W resistor between the motor outputs to make it to a dummy load/motor. Then you can use it as a function only decoder and you can change the mapping and light effects after the installation. You do not need to take it out to connect to a motor to do the CV settings.