Servo Bracket from Tam Valley Depot
3D Printed Micro Servo Bracket Kit (servo not included)
This bracket is designed to mount underneath the layout and actuate the points with a spring wire. To munt the servo a single screw and gap-filling CA glue (hold in place with a rubber band until dry) is used. You are free to use this bracket in other creative ways if you feel the need to experiment. Comes with a piece of foam tape for easy attachment to the layout and two 1/2" x #4 screws for permanent attachment. A #4 screw fits snugly in the mounting holes so that when you are under the layout the screws will not fall in your face. Also comes with a piece of music wire.
Specs
Actuating Wire- .032" steel music wire. Length - 5" before assembly; 3" usable length after assembly (maximum thickness of subroadbed + track height)
Bracket Size - 1 3/16" wide x 1.0" deep X 1 3/16" high
Fits servo size 0,87" (23mm) wide x .47" (12mm) deep (SG90, 9g servos).
| Featured Product | No |
|---|
MENU
