SC82 SERVO CONTROLLER WITH SERIAL BUS

More Views

SC82 SERVO CONTROLLER WITH SERIAL BUS

Availability: In stock (5)

£57.80
Order number: SC82

Manufacturer: Team Digital
OR
Description

Details

Features: • DCC compatible accessory decoder • Controls 8 servos • "Power Save" greatly reduces current requirements • Programmable position and speed of servos • Simple semaphore signal control • Inputs for local control of servos • Remote controlled routes for turnouts • Digitrax LocoNet® compatible serial bus • DCC gateway to serial bus • Support for Berrett Hill Touch Triggers with optional interface board Operation: There are two basic modes of operation that determine how the servo is used. The first basic configuration is moving servos to two positions. Mode 1 - The servo outputs can be used for turnout control. There is a separate address for each output so they can be controlled individually. There are a total of eight switch addresses. In this mode a servo could also be used for crossing gates. The second basic configuration is for moving servos to three positions. Mode 2 - The servo outputs can be used for semaphore control. There are a total of 24 switch addresses. In this mode three addresses are used to control each servo, address A(throw) will command the servo to one end, address A+1(throw) will command it to the center and address A+2(throw) will command it to the other end. Servos can easily draw 2 or 3 times the current of a Tortoise™. "Power Save" is a default option that essentially allows the SC82 to remove operating power from the servo when it is not moving. Since turnouts are not operated continually this can 'save' a lot of power. Two types of route control are supported. The remote controlled routes are controlled from the throttle just like a single switch is, except that multiple switches may be activated. The local routes are activated by using the inputs. Routes are configured by programming the respective CVs as to which outputs are selected in the route and the output state. Compatibility: The SC82 is not fully compatible with the Atlas, Backmann or MRC (except Prodigy Advance) DCC systems because they do not support accessory commands or can not program the number of CVs in the SC8. Features differences from SC8: • Outputs for LED turnout state indication. • Semaphore signal control. • Improved method of programming servo position. • Ops mode address can be greater than 127 using LocoNet® and JMRI. • No “Speed_to_Position” .
Delivery & Returns

Delivery & Returns

If returning any product please can you ensure you send it back to us with proof of purchasing, a covering letter and contact details. See terms and conditions for full information on our returns policy.